B-52 US-1200 Series - PROFESSIONAL POWER AMPLIFIER AMP - *** New in the Box ***

Description

B-52
1200 PROFESSIONAL POWER AMPLIFIER
***
NEW
-
OLD STOCK
***
Item has been discontinued from the manufacturer
This is the
Last One
That We Have!
SAVE
!!!
Manufacturer's Description
We at B-52 believe in overbuilding all of our products and the US-Series Professional Power Amplifiers are no exception. We took our time in designing these stellar looking amps to outperform the competition on any stage, in the clubs and on the road. To achieve studio quality audio reproduction we utilized low noise, low distortion circuitry and high current output stages. We used oversized toroidial transformers and large filter capacitors to deliver super clean, fist pumping output even when driving a 2 ohm speaker load. These amplifiers use the most reliable linear output devices which provide ultra low distortion and ruler flat frequency response. The US-Series is backed by our rock solid 3-year warranty and our commitment to reliability known the world over.
• High-current toroidal transformers for greater 2-ohm power
• 21-position detent gain control knobs for consistent settings
• Front panel LED display: Power, bridge and parallel LEDs and signal,
-20dB, -10dB, 0dB, clip and protect LEDs for each channel
• Protection: short circuit, output current limiting, thermal, DC
offset, turn on/off muting, RF protection and circuit breaker
• Clip limiters reduce distortion without sacrificing peak performance
• Sub-sonic filters protect speakers and increase headroom (defeat-able)
• Balanced combo XLR and 1/4” TRS input connectors and link XLR output connectors
• 5-Way binding post and Speakon TM outputs
• Low-noise cooling fans with continuously variable speed and highly
efficient front-to-rear forced air keeps the amplifiers cool
US-1200
Stereo Both Channel Driven @ 1kHz, 1% THD
8 Ohms - 210 watts
4 Ohms - 330 watts
2 Ohms - 430 watts
Bridged Mono @ 1kHz, 1% THD
8 Ohms - 650 watts
4 Ohms - 850 watts
Input Sensitivity:
1.23 Vrms (+4 dBu) for full power @ 4 Ohms
Input Impedance:
30K ohms Balanced/15K ohms Unbalanced
Frequency Response:
0/-0.5dB: 20Hz - 20kHz; 0/-3dB: 5Hz - 60kHz
Signal to Noise Ratio:
Better than 100dB (20Hz - 20kHz)
Distortion (SMPTE-IM):
Less than 0.03%
Output Circuitry:  AB
Cooling
Continuously variable speed fan, front to rear
Protection
Short circuit, thermal, current limit, dc offset, AC current inrush,
RF protection, subsonic, turn on/off muting
Connectors
Input: Combo female XLR & 1/4” TRS jack. Link: Male XLR
Output: Both 5-way biding post and Speakon™
Controls
Front: Power on/off switch, volume controls for each channel
Rear: Mode switch (stereo / parallel / bridge), HPF on/off,
Limiter on/off (US3000/4000)
Indicator
Power, parallel, bridge. Each channel: Signal, -20dB, -10dB, clip, protect
Power Requirements
115/230V 60/50Hz factory configured
AC consumption
Both channels driven at 4 Ohm load, at 115Vac (for 230V divide by 2)
Controls
Front: Power on/off switch, volume controls for each channel
Dimensions
19" (482mm) x 3.5" (88mm) x 17.2" (438mm)
Net weight
28lb (13kg)
***
EMAIL US WITH ANY QUESTIONS
***
Terms
:
- Will
Only
Ship Within the
48 U.S. States
-
Payment Must be Received
Within
24 hours
of Close of Auction
We are not a B-52 dealer - so no warranty implied - Item is New in the Box (unopened)
-
Confirmed Shipping Address
Required
(Item will ship via FedEX Ground or UPS Ground - Upon Receipt of Payment)
Please check out our other eBay auctions - sometimes have items from the following brands
:
Ampeg, Blackstar, Egnater, ESP, Fender, Gibson, Ibanez, Jackson, JBL, Korg, Mackie, Marshall, Orange, Paul Reed Smith, PRS, Peavey, Schecter, Strymon