LEE 2 Cavity Bullet Mold 90382 450-200-1R 200 Grain SAME DAY SHIPPING

Description

Lee Double Cavity Mold produces two .450 diameter 200 grain round nose bullets for the 45 ACP, 45 Colt, 45 Auto Rim and many other 45 caliber cartridges.
This mold is the NEW Lee design, with the steel locating pins like the 6-cavity mold.
This mold includes a free set of handles and will pay for itself with the first hundred bullets you cast.
BRAND NEW IN THE FACTORY BOX, IN STOCK AND READY TO SHIP. WE ARE A LEE MASTER DISTRIBUTOR AND HAVE MANY OTHER GREAT LEE PRODUCTS LISTED.
Lee aluminum molds are the best value in bullet molds.
The aluminum blocks do not rust like cast iron molds, and are lightweight for less fatigue and ease of use.
You can also quickly switch to a different mold while casting, as it can be quickly heated by dipping the corner of the mold in the lead pot. No other pre-warming required or wasting time with bad cast bullets while waiting for the mold to come up to temperature.
We only list items that we have in stock and ship most orders by the next business day. Thanks for looking, check out our other items for great deals on shooting supplies and reloading equipment by clicking the following link:
We combine items for a shippng discount, please click this link to visit our Ebay store before you check out.
Returns accepted if you are not satisfised. Our feedback speaks for itself.
For Buyer protection, we can only accept payment thru PayPal, and can only ship to the address you provide at check out.
PLEASE BE SURE YOUR SHIPPING ADDRESS IS CORRECT WHEN YOU CHECK OUT. IT CANNOT BE CHANGED LATER.
Thanks for looking, Mark @ Shooting Supply
Satisfaction Guaranteed By Lee
From the Lee website:
Lee mold blocks are machined from aluminum blocks because of its exceptional molding qualities. Aluminum molds heat up and cool down faster than iron or steel molds so good bullets can usually be produced after only a few casts. Lee molds produce bullets faster than iron or steel molds due to the minimized down time between casts. In addition, they are one-third the weight of iron or steel mold blocks for less fatigue during extended casting sessions. To ensure the best possible bullets, mold block halves are clamped together and then lathe-bored for unmatched roundness and size control. All Lee 1- and 2-cavity molds come with mold handles and hard anodized sprue plates. Weights given are Lee's weights with suggested alloy; actual weight may vary due to alloy mixture used.